GB flag iconENCN flag iconZH

Webinars and Online Resources


Access to Bulletin expert articles is reserved for members only.


Using the SATRA STM 603 slip resistance tester – part 1

Explaining the importance of how correct test specimen preparation, machine set up and procedures can ensure that this equipment gives accurate and valuable results.

Any incorrect preparation of test specimens or setting up of a slip resistance tester will lead to inaccurate coefficient of friction (CoF) values. This can lead to specimens that are close to the requirements either passing when they should not, or failing to pass when they should do so. This article will explain the correct preparation of specimens followed by the set up and testing procedure on the SATRA STM 603 slip resistance tester.



Please see how SATRA Membership could benefit you.

To request access please enter your email address below.